Grounding and Bonding and The NEC - Section 250
GENEVA, NY -
The Electricity Forum is organizing a series of live online Electrical Grounding and Bonding - NEC 250 training courses this Fall:
- September 8-9 , 2020 - 10:00 am - 4:30 pm ET
- October 29-30 , 2020 - 10:00 am - 4:30 pm ET
- November 23-24 , 2020 - 10:00 am - 4:30 pm ET
This interactive 12-hour live online instructor-led Grounding and Bonding and the NEC Training course takes an in-depth look at Article 250 of the National Electrical Code (NEC) and is designed to give students the correct information they need to design, install and maintain effective electrical grounding and bonding systems in industrial, commercial and institutional power systems.
One of the most important AND least understood sections of the NEC is the section on Electrical Grounding.
No other section of the National Electrical Code can match Article 250 (Grounding and Bonding) for confusion that leads to misapplication, violation, and misinterpretation. It's generally agreed that the terminology used in Section 250 has been a source for much confusion for industrial, commercial and institutional electricians. Thankfully, this has improved during the last few revisions to Article 250.
Article 250 covers the grounding requirements for providing a path to the earth to reduce overvoltage from lightning, and the bonding requirements for a low-impedance fault current path back to the source of the electrical supply to facilitate the operation of overcurrent devices in the event of a ground fault.
Our Electrical Grounding Training course will address all the latest changes to the Electrical Grounding rules included in the NEC.
Our course will cover grounding fundamentals, identify which grounding system tests can prevent safety and operational issues at your facilities and details regarding which tests can be conducted while the plant is in operation versus which tests require a shutdown will be discussed.
Proper electrical grounding and bonding of equipment helps ensure that the electrical equipment and systems safely remove the possibility of electric shock, by limiting the voltage imposed on electrical equipment and systems from lightning, line surges, unintentional contact with higher-voltage lines, or ground-fault conditions. Proper grounding and bonding is important for personnel protection, as well as for compliance with OSHA 29 CFR 1910.304(g) Grounding.
It has been determined that more than 70 per cent of all electrical problems in industrial, commercial and institutional power systems are due to poor grounding, and bonding errors. Without proper electrical grounding and bonding, sensitive electronic equipment is subjected to destruction of data, erratic equipment operation, and catastrophic damage. This electrical grounding and bonding training course will National Electrical Code.
Complete course details here:
https://www.electricityforum.com/electrical-training/electrical-grounding-nec
Related News
Climate change: Greenhouse gas concentrations again break records
LONDON - The World Meteorological Organization (WMO) says the increase in CO2 was just above the average rise recorded over the last decade.
Levels of other warming gases, such as methane and nitrous oxide, have also surged by above average amounts.
Since 1990 there's been an increase of 43% in the warming effect on the climate of long lived greenhouse gases.
The WMO report looks at concentrations of warming gases in the atmosphere rather than just emissions.
The difference between the two is that emissions refer to the amount of gases that go up into the atmosphere from the use of fossil fuels, such…
