DAY ONE
Part One: Introduction To Cable Splicing and Terminating Technologies and Standards
- Splicing Technology
- Modular
- Molded
- Tape Systems
- Shrink Technologies
- Other
- Terminations
- Modular
- Molded
- Tape Systems
- Shrink Technologies
Part Two: Medium Voltage Splicing and Termination
- Material Technology
- Human Factors in Splicing
Part Three: Types of High Voltage Cables
- Tape Shielded
- Drain Wire Shielded
- BICC UniShield
- Concentric Neutral (CN)
- Jacketed Concentric Neutral (JCN)
- Type of Configurations
Part Four: High Voltage Cable Components
- Conductor
- Concentric Stranding
- Compressed Stranding
- Compact Stranding
- Strand Shielding
- Insulation
- Insulation Shield System
- Metallic Shielding
- Jacket
- How Solid Dielectric Cables are Made
DAY TWO
Part Five: Cable Installation and Handling
- Safety
- Environmental Protection
- Light, Power and Ventilation
- Housekeeping
- Cable Handling
- Direct Bury
- Duct and Tray Installation
- Causes of Cable Failures
Part Six: Cable Preparation
- Safety
- Hand Tools
- Abrasives and Solvents
- Supplies and Materials
- Cable Preparation Procedures
- Cable Prep Lab
Part Seven: Cable Splicing Demonstration
- Molded Splice
- Taped Splice
- Heat Shrink Splice
- Cold Shrink Termination
- Elbow Termination
Part Eight: Cable Testing Methods
- Insulation Resistance
- DC Hipot
- Very Low Frequency Testing
- Partial Discharge Testing
- Power Factor Testing
- Cable Testing Lab
Review of expectations
Questions and Answers
COURSE TIMETABLE
Both days:
Start: 8:00 a.m.
Coffee Break: 10:00 a.m.
Lunch: 12:00 noon
Restart: 1:15 p.m.
Finish: 4:30 p.m.